SERVICE

The wax is injected directly into a mold, cold/hot wax, low/high injection pressure, most factory do not care this step too much, but we pay attention to it very much, because the wax mold determines the final surface quality and fitment, for G.E.T wear parts fitment must be good, for Europe market many small earthmoving machines, so always small bucket teeth, fork teeth and adapters, good finishing can catch the customer from the first glance.

coated with refractory material(sand & refractory mortar) and a binding agent(water glass & chemical liquid), usually in 6 or 7 stages to build up a thick shell.

All our G.E.T parts is investment/ lost-wax casting, no any sand casting parts. Some of the central advantages and disadvantages of investment casting include:

1. 1、A high degree of accuracy and precise dimensional results.
2. 2、The ability to create thin-walled parts with complex geometries -- small bucket tooth or small fork tooth can be produced.
3. 3、Relatively high-quality surface finish and detail in final components.

We have 2 different type of machine to do the heat treatment. construction parts means small tooth and adapter--mesh belt furnace; then mining parts and big ones such as Caterpillar J550--J800, Esco Super V from V43--V81--tunnel furnace.

All the big mining tooth and adapter, such as 1U3552RC, 6I6602RC, V71SD...... we will check all by the X-ray flaw detection, it can help us to find out the parts which is crack inside or from the riser. Mining parts must make sure no crack then no break.

We use the gauge check the bucket teeth, adapters, fork teeth one by one to make sure that all the parts can be fitted well.

We can painting in colors like yellow, black, green, ect to fit different brands and machines .

Nylon bad, plywood box, each box from 800-1200 kgs roughly(depend on the shape).